M/s
Laxmi purchased old AMADA CNC turret punch press were looking for a solution for
NC programming for their
CNC TPP. Again it is a retrofitted with some other controller. Who can give me
programming software as well total
support to run this machine successfully.? Was the question from promoters of
M/s Laxmi.
Antech has a unique solution for this.
ANACAM with DNC was installed. Programming support was provided. NC operators
were given after on job training.
" Who will do all this ? and that is too at such a reasonable cost, "
Says Mr.Brahme of Laxmi | 
